C0110 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.
C0110 OBDII Repair :C0110 code shows that location the body harness connector, located in and around the left hand kick panel area or inside the IP (consult a shop manual for location). Water can leak into the connector from clogged sunroof drains, A-pillar leaks, or windshield or cowling leaks.
The crank but won't start condition, along with the trouble codes may make you think you've got a PATS anti-theft system problem. However, Ford reports that these codes are all related to software bugs. The only way around the problem is to reprogram the PCM with the latest software.
Brake Switch Out of Self-Test Range Indicates that during Key On Engine Off (KOEO) Self-Test, BPP signal was high. Or during Key On Engine Running (KOER) Self -Test, the BPP signal did not cycle high and low. Open or short in (BPP) circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit (Rear Electronic Module [REM] Windstar and LS6/LS8 and Lighting Control Module (LCM) Continental and Town Car) Damaged Brake Switch Misadjusted Brake Switch Check for proper function of stoplamps. Follow correct Self-Test procedures, refer to Section 2, Quick Test.
Please fill the search bar to find Auto Trouble Code meaning.